Lotus Europa Forums > Technical Articles and DIY tools and tips
True reading for Stromberg Fast Idle cam setting
(1/1)
Bryan Boyle:
Reading the "official" Lotus service manual TC supplement (Section L.11, paragraph 1) to set the fast idle cam, it says to use a .6mm drill bit to open the throttle and adjust the screw when the fast start is fully engaged.
.6 mm? That's 0.023622 inches. Really? Only thing I have close would be a roll of 22 ga wire (which is .0226). close enough for government work?
SilverBeast:
You could always get a micro drill bit set from Ebay if you think it's that critical.
Bryan Boyle:
--- Quote from: SilverBeast on Monday,March 14, 2022, 02:01:09 AM ---You could always get a micro drill bit set from Ebay if you think it's that critical.
--- End quote ---
Not critical, just would like to try and get it close. I'll use the wire and give it a little extra turn. Probably as close to factory as anything on this car ever was.
Navigation
[0] Message Index
Go to full version