1
Garage / Re: It's not easy being green - 1971 TC
« Last post by EuropaTC on Today at 02:15:23 PM »Yep, looks like the access hole to remove the door pin (now there's a job to look forward to )
If you get underneath & look up you should see the bottom of the 1/2" steel door pin. This is threaded (1/4" ?) which you can make up a slide hammer arrangement to pull it down/out with the car in the air. In practice, if this is the first time around then it's more than likely rusted solid, release fluid might get it loose but be prepared to cut it away or get mole grips from inside the door to get it started.
If you get underneath & look up you should see the bottom of the 1/2" steel door pin. This is threaded (1/4" ?) which you can make up a slide hammer arrangement to pull it down/out with the car in the air. In practice, if this is the first time around then it's more than likely rusted solid, release fluid might get it loose but be prepared to cut it away or get mole grips from inside the door to get it started.