...are they made from a single piece or welded...good question....I assumed they were one piece...I left them at work...Can you weld EN24? ....seem to remember that one had to be very careful and it required welding with the en24 metal at very high temperatures......but I read it a long time ago not sure if I remember correctly anyway these things are used in his single seaters so I am pretty confident they'll be strong enough.
So my plan is right hand thread on left hand side and left hand thread on right hand side....That was the advice from Peter at PA
Anyway, should be fun trying this.....will assemble all the parts I need before I start....so far the last retightening using lock tight has actually worked rather well...ironically!
Serge Sleurs has a good episode about putting the hub together on you tube...so intend to have the manual to hand and watch Sleurs a few times before I start