« previous next »
Pages: [1]   Go Down

Author Topic: Vacuum take off  (Read 237 times)

0 Members and 1 Guest are viewing this topic.

Offline europa88

  • Jr. Member
  • **
  • Joined: Mar 2013
  • Location: Oxfordshire UK
  • Posts: 79
    • Europa88
Vacuum take off
« on: Wednesday,July 28, 2021, 06:55:17 AM »
Hi does anyone know what the thread size and type is on the vacuum take off on a Dellorto inlet manifold?
I have removed the brake booster and want to blank it off neatly (I currently have a short bit of hose and a bolt with worm drive clips
Logged
If you no longer go for a gap that exists, you are no longer a racing driver.

Offline MRN I J

  • Sr. Member
  • ****
  • Joined: May 2020
  • Location: Knowle, Solihull, West Midlands, UK
  • Posts: 259
    • Four Ashes Garage
Re: Vacuum take off
« Reply #1 on: Wednesday,July 28, 2021, 11:06:01 AM »
most likely 1/8 bsp as thats been industry std for many years on servo take offs, just a bit bigger than 3/8 at 0.383" od, taper plugs are easily available.
Logged
Regards Chris

other cars inc wifes cars
Aston Martin DB MkIII DHC (wifes)
Aston Martin DB2 Saloon (shared)
MkI Austin Cooper S with less than 50k miles on it
Oldest existing LR Discovery S3, one of 1st 125 hand built cars
Peugeot 406 with less than 55k miles on it

Offline europa88

  • Jr. Member
  • **
  • Joined: Mar 2013
  • Location: Oxfordshire UK
  • Posts: 79
    • Europa88
Re: Vacuum take off
« Reply #2 on: Wednesday,July 28, 2021, 01:14:05 PM »
Quote from: MRN I J on Wednesday,July 28, 2021, 11:06:01 AM
most likely 1/8 bsp as thats been industry std for many years on servo take offs, just a bit bigger than 3/8 at 0.383" od, taper plugs are easily available.

Thanks Chris  :)
Logged
If you no longer go for a gap that exists, you are no longer a racing driver.
Pages: [1]   Go Up
« previous next »