1
Garage / Re: Lotus Factory Tour
« Last post by BDA on Today at 12:16:37 PM »Thanks for the great pictures!! It's nice to see such a nice grave marker for Jim Clark.
July 1, 2023 Forum membership reaches 1,465 !!
This Community became 11 years old in April 2023.
They show up FS from time to time. Here's a few that sold on BAT this year. https://bringatrailer.com/jensen/jensen-healey/I have always thought the Jensen Healey was a bit of a chunky looking roadster, but that Jensen GT is a good looking car. Still a shame about those front bumpers, though. I'm not sure if I was aware of these.
Including that rare Jensen GT. I was tempted to bid on that as my next project, but wised up in time to save myself Interesting fact I read is that Donald Healy resigned from the JH board because new American owner, Kjell Qvale, decided to position this model upmarket as a sort of a "junior" Jensen Interceptor, and dropped the Healy name. Thus, Jensen GT.
Ron
Is it possible to use a banjo fitting in that "tight install".
Presumably the port external surface would need to be a machined flat surface and perhaps some aren't? . . dunno.
I've noticed Wilwood have adaptors for banjo fitting so I'm not sure.
Thank you for your response. I have the same concern, that's why I am asking here.
"The ideal humidity for rust-free storage of automobiles is between 50 and 55 % RH (relative humidity)"
I'm not sure what the situation in an enclosed trailer is throughout the year.
The paint eventually started erupting, with small leopard spots appearing all over it.