91
Garage / Re: What are we missing, what should I make on a VMC?
« Last post by Richard48Y on Tuesday,May 14, 2024, 11:33:46 AM »Looking at older threads it seems there may still be interest in upgraded uprights.
They could be made as billet but the material cost would be very high.
Alternately permanent molds could be made to produce patterns for casting.
But again, too many ambulance chasers in the US?
What about these?
FI Body to intake adapters.
Engine to transmission adapters.
Good air filter assemblies.
Weber reinforcement plates.
They could be made as billet but the material cost would be very high.
Alternately permanent molds could be made to produce patterns for casting.
But again, too many ambulance chasers in the US?
What about these?
FI Body to intake adapters.
Engine to transmission adapters.
Good air filter assemblies.
Weber reinforcement plates.