Recent Posts

Pages: 1 ... 9 [10]
91
eBay - Craigslist Ads - Other Listings / Re: '72 TC Project FS on Craigslist in Boston
« Last post by Bryan Boyle on Thursday,April 18, 2024, 02:30:28 PM »
I've seen worse for more $.  9K+ is probably a stretch, I'd be more interested in it at 7-7500.
92
Garage / Re: Freeing up potentially rusted piston rings to cylinder
« Last post by Grumblebuns on Thursday,April 18, 2024, 02:18:41 PM »
It took a little bit of effort but I got the engine to break free and rotate freely. I was initially going to use ATF/acetone mixture but I discovered that my can of acetone had evaporated away long ago and my can of WD40 had lost its air pressure. At that time I was tired and most likely too lazy to make the 25 miles round trip to the hardware store in town. I did have a can of PB Blaster which I decided to use. The piston rings probably were not too badly rusted to the cylinders but the PB Blaster did the job. Once I finish the leak down test I'll pour in some light lubricant to coat the piston walls for long term storage.
93
Garage / Re: TCS black paint under door sill trim
« Last post by Kendo on Thursday,April 18, 2024, 12:15:06 PM »
Yes, BDA. That looks good. Many thanks.
94
Resources, Parts and Products / Re: Carbon Fiber - Molding projects - Reproduction panels
« Last post by TurboFource on Thursday,April 18, 2024, 12:01:11 PM »
Excellent!
95
Resources, Parts and Products / Re: Carbon Fiber - Molding projects - Reproduction panels
« Last post by cazman on Thursday,April 18, 2024, 11:29:19 AM »
No contest!
96
Garage / Re: TCS black paint under door sill trim
« Last post by BDA on Thursday,April 18, 2024, 10:21:44 AM »
Is this what you're talking about?
97
Garage / TCS black paint under door sill trim
« Last post by Kendo on Thursday,April 18, 2024, 09:51:38 AM »
Does anyone have a good picture of a TCS with black paint below the door sill trim? Preferably on a car not painted black :) I know we discussed this in the past. But I can't find the thread. I want to get an example to my painter so he knows what I'm talking about.
98
Resources, Parts and Products / Re: Carbon Fiber - Molding projects - Reproduction panels
« Last post by Chuck Nukem on Thursday,April 18, 2024, 09:07:31 AM »
Thanks BDA!

I think I'll just leave these photos here for everyone's thoughts on the matter.... :)
99
Resources, Parts and Products / Re: Carbon Fiber - Molding projects - Reproduction panels
« Last post by BDA on Thursday,April 18, 2024, 08:58:42 AM »
More great stuff, Chuck!!  :beerchug:
100
Resources, Parts and Products / Re: Carbon Fiber - Molding projects - Reproduction panels
« Last post by Chuck Nukem on Thursday,April 18, 2024, 08:56:41 AM »
We are getting closer. The backside mold is complete. Now only the front side remains!
Pages: 1 ... 9 [10]